DESCRIPTION:-
PROCESS:
Raw Water Pump? Sand Filter ? Carbon Filter ? Anti Scalent Dosing System ?
Micro Filtration? High Pressure Pump ? Membrane.
FEED WATER 1000 LPH
FEED WATER TDS 1000 PPM
PRODUCT WATER 250 LPH
RECOVERY 60%
REJECTION 95%
In case of high Turbidity customer needs to provide a settlement
tank and Alum dosing system is to be incorporated. The cost of the same has not
been considered with in the scheme.
TECHNICAL SPECIFICATION
FEED Water Pump
The system would require an Inlet Pressure of 1.5 Kg/cm2 minimum for smooth
operation. To provide the same the Raw Water Pump is being incorporated in the
system.
Description
Make : Kirlosker/Shakti
Power : 1 Hp
230 volts
Phase : Single
Type : Mono Block
PRESSURE SAND FILTER
The system is required to be feed with “0” turbidity water. The
Pressure Sand Filter is incorporated in the system to ensure the same. The
Pressure Sand Filter offers a filtration up to 30 microns.
The Filter consists of a Non Corrosive Vessel that can withstand
pressure up to 6.5 Kgs/cm2, Multi Graded Sand Filtration Media for filtration,
Internal Distribution System to distribute the water evenly inside the vessel
for proper filtration, Multi Port Value (MPV) for easier operation along with
Back Wash and Rinse facilities, a stand to hold the MPV in position and
Pressure Gauges to know the position of the sand filter.
The filter is designed for 14m/sec internal flow for proper
filtration.
Description:
Vessel : FRP
Size : 1054”
Multi Port Value Filter : 25 mm Top Mounted
Media : Silica Sand Multi Grade
Min Operating Pressure : 1.5kg/Cm2
Max Operating Pressure : 4.5kg/Cm2
Avg Operating Pressure : 2-3kg/Cm2
ACTIVATED CARBON FILTER (ACF)
This system is required to be feed with NIL Chlorine water. The
Activated Carbon Filter is incorporated in the system to ensure the same. It
also ensures that the water is color less, odor less and contains no dissolved
gases.
The Filter consists of a Non Corrosive Vessel that can withstand
pressure up to 6.5Kgs/cm2, Multi Graded Sand and Activated Carbon Filtration
Media for filtration, Internal Distribution System to distribute the water
evenly inside the vessel for proper filtration, Multi Port Value (MPV) for
easier operation along with Back Wash and Rinse facilities, a stand to hold the
MPV in position and Pressure Gauges to know the position of the Activated
Carbon filter.
The filter is designed for 14 m/sec internal flow for proper
filtration.
Description:
Vessel : FRP
Size : 1054”
Multi Port Value : 25 mm Top Mounted Filters
Media : Activated Carbon
Min Operating Pressure : 1.5kg/Cm2
Max Operating Pressure : 4.5kg/Cm2
Avg Operating Pressure : 2-3kg/Cm2
ANTI SCALENT DOSING SYSTEM
The ANTI SCALENT DOSING SYSTEM gives the system an extra
protection towards any kind of scale formation over the membranes. Chemicals
are chosen depending on the water analysis report of the raw water. These
chemicals are dosed in the water inflow drop by drop. The chemicals agitate the
dissolved particles in the water so as not to allow them to settle down on the
membrane surface.
Description:
Make : E-Dose
Type : Diaphragm Type Metering Pump
MOC of Diaphragm : PP
Capacity : 6 LPH
Dosing Tank (100 Ltr) HDPE
Anti Scalent Chemical : 1 Litre
MICRON FILTER
Due to the induction of the dosing chemical some of the particles may coagulate
in the water. This coagulated particle cannot be allowed to enter the membrane.
The Micron Filter ensures that all such particles above the size of 5 micron
are being filtered out of the water so as to enhance the system life. It also
ensures that even all undissolved particles above the size of 5 Micron are
being filtered out.
Description:
No. Offered : One
Jumbo Housing : PP
Specification : One
Filters Nos. Offered : One
Micron Rating : 5 Micron
HIGH PRESSURE PUMP
In the system, the membrane filtration takes place at high
pressure only in the range of 8-14 KG/CM2. To provide such high pressure the
Pressure Booster Pump is being induced in the system to boost the pressure to
the required level for the proper filtration process.
Description:
Make : Kirlosker/Shakti/Lubi
Power : Single Phase
Type : Horizontal/Vertical Multi Stage
Pressure Rating : 1.5 M3 At 140m Head
Max Pressure : 17 Kgs/Cm2
Normal Operating Pressures : 8-14 Kgs/Cm2
MEMBRANE HOUSING
The membrane housing provides the shell for the membranes to allow the highly
pressurized water to pass through the membrane.
Description:
MOC : FRP
No. Offered : One
Specs : 4:40 (Single Element)
Max Pressure : 21 Kgs/ Cm2
Operating Pressure : 9-14 Kgs/ Cm2
MEMBRANE
The system consists of Thin Film Composite Membrane made out of Poly Urethane
acetate that provides a filtration level up to 0.0001 micron. These operate at
a pressure between 9-14 kgs/cm2 this result in a dissolved salt rejection of up
to 95%. The membrane separates the water into two streams. One is the premed or
the product water and the other is the rejection.
Description:
Specs : 4040
No. Offered : One
Operating Pressure : 9-14 Kgs/ Cm2
ACCESSORIES
ELECTRICAL CONTROL PANEL
MOC : Plastic
Power : Single Phase
Condutivity Meter : Inbuilt
LPS Adjuster : Inbuilt
HPS Adjuster : Inbuilt
WET PANEL
MOC : Plastic
Flow Meters : Two
Pressure Gauges : Two
LPS : One
HPS : One
SKID
MOC : Stainless steel
PIPING
Raw Water Pump To Micron Filter : UPVC
Micron Filter To Flow Meters : UPVC
Product Line : UPVC (As Per FDA &NSF)
Reject Line : UPVC
